Introduction of Din41612

DIN41612 connectors mainly have parallel connection and vertical connection. The connection form is: straight hole - curved needle, vertical connection of curved hole - straight needle, parallel connection of curved hole - curved needle. The number of contact points are: 20, 30, 32, 40, 64, 96, 120, 128, 160, etc. The products are used in the connection between the backplane and the daughter board of optoelectronic equipment, the connection between the backplane and the daughter board of industrial control equipment, the industrial control of consumer electronics, the connection between the backplane and the daughter board of industrial control security control, etc. Its application industry: used in consumer electronics, monitors, computers, PCB boards, instrumentation, intelligent robots, electrical appliances, new energy vehicles, color TVs, air conditioners, photovoltaics, security, mobile phone industry, CNC and other industries!

There are 2A, 6A, 15A, etc., signal type, power type and mixed type of different media, the product has a wide range of applications. There are four installation forms of backplane, parallel board, common panel, and wire-to-board, which can quickly connect and improve work efficiency.

Classification

Classified by working current

Ordinary type (2A), high current type (6A), power type (15A).

Classified by Termination Form

Soldering type, crimping type, crimping terminal type, IDC piercing insulation type.

Din41612 connectors are generally used for signal or power connection below 3MHZ, not suitable for signal connection above 10MHZ; when used for 3~10MHZ signal connection, isolation method is required, and ground pins are inserted between each signal pin to avoid two Adjacent signals influence each other, resulting in greater crosstalk.

There are two installation and fixing methods, one is the harpoon fixing method. In this method, the fixing pin will be welded to death during welding, which is not conducive to maintenance and disassembly. The other is the screw fixing method. This method needs to be matched with screws, nuts, flat washers and gaskets. The process operation is more complicated, and the advantage is that it is easy to disassemble. When the technological level reaches a high level, it is recommended to use a harpoon, and a screw fixing method is recommended at this stage. When the European connector has insulation requirements, the selection of electrical clearance and creepage distance should be considered.